-38-
Model W1763W (For Machines Mfd. Since 09/16)
O
PE
R
ATIO
NS
Hold-Down
The hold-down is used to hold the workpiece flat on
the work table and snug against the fence to allow for
consistent shaper cuts
.
A hold-down DOES NOT replace standard safety features.
Always keep hands and entanglement hazards away from
the cutting area to avoid contact, and ensure proper
safety guards are in place during the cutting process.
To.use.hold-down,.do.these.steps:.
1. Ensure fence carriage is positioned properly for
cutting operation, and that both fence carriage lock
knobs are tightened (see
Figure
52
).
2. Loosen cap screw securing hold-down bracket to
support arm (see
Figure
52
), and slide hold-down
along arm to properly support workpiece; tighten
cap screw.
3. Loosen height knob to lower or raise hold-down to
proper height above workpiece (see
Figure
53
).
Note: Workpiece should move freely beneath hold-
down, with little to no contact during full range of
operation.
4. Use a similar sized test piece to ensure hold-down is
properly aligned.
Note:
Remove hold-down assembly when not in use.
Figure
52
. Moving hold-down outward to
support workpiece.
Fence
Carriage Knob
(1 of 2)
Hold-Down
Figure
53
. Lowering hold-down to test fit
workpiece.
Hold-Down
Height Knob
Workpiece
Hold-Down
Bracket