-28-
Model W1763W (For Machines Mfd. Since 09/16)
O
PE
R
ATIO
NS
The Model W1763W comes with
1
⁄
2
" and
3
⁄
4
" spindles.
Each spindle is sized to work efficiently with cutters and
spacers that have
1
⁄
2
" and
3
⁄
4
" bores. The spindles must
be inserted correctly and remain stationary in order
to produce quality work. When installing and changing
spindles, make sure the spindle seats snugly and that
there is enough drawbar threaded into the bottom of the
spindle to safely secure it in place.
To.install.a.spindle,.do.these.steps:
1.
Remove both hex nuts from
3
⁄
4
" spindle. Remove hex
nut and keyed washer from
1
⁄
2
" spindle.
2. Thread short threaded end of drawbar approximately
10-15 turns into bottom of spindle (
see
Figure
33
)
.
3. Place spindle/drawbar into spindle cartridge from
top of table. You will feel spindle seat itself.
4. Thread tapered drawbar nut with tapered side up,
onto bottom of drawbar (see
Figure
34
)
.
5. Place spindle wrench on top of spindle, so it fits into
spindle flats. Place a 14mm wrench on drawbar nut
(see
Figure
35
)
.
6. Hold spindle in place and tighten drawbar nut. DO
NOT use excessive force.
Spindle.Installation
Incorrect assembly can allow the spindle and cutter
to fly off the machine, which could cause injury or
death. Make certain the spindle is properly assem-
bled before operating the shaper. If you are uncer-
tain of any aspect of this assembly, please review
these instructions again or contact our Technical
Support.
Figure 34. Nut threaded onto drawbar.
Figure 35. Tightening drawbar nut.
Tool.Needed.
Qty
Spindle Wrench ..................................................1
Spindle
Drawbar
Short Threaded
End
Figure.33.
Spindle and drawbar assembly.