22
2.2.3 Product Package (WA512G-D)
Standard package includes:
1x Product Unit
1x Quick Installation Guide
2x WLAN Antenna, White
The Antenna supports 2.4G/5G wide range. Attached them to ANT1 and ANT2 sockets.
1 x Attached Din Clip
Note:
The model doesn’t offer PoE injector. If you need additional PoE injector or PoE switch, check with our
sales contact window.
2.2.4 Interface Installation
After unpacking the box, follow the steps below in order to properly connect the device.
2.2.4.1 Wiring Power Input
The WA512G-D supports DC terminal block with 24V(9~50V) DC input. The typical power input voltage is 24VDC.
Wire the power po) and native(-) correctly before turn on the power supply.
WA512G supports standard IEEE 802.3af PoE Power Device (PD), it can be powered by PoE switch (P.S.E) or PoE
injector. WA512G equips with gigabit Ethernet ports and dual WLAN radio, it’s MUST to choose full gigabit PoE
Switch with higher Ethernet bandwidth, for example the DP208, DP412, DP612.
The standard package in WA512G-D does NOT have PoE injector inside. You can buy our passive 48V (not
standard 802.3af/at PoE), you can also choose standard IEEE 802.3af/af PoE Injector for powering. You can aslo
buy our PoE Switch.
Wiring the Power Input through DC Terminal Block
1) Insert the positive and negative wires into the V+ and V- contact on the terminal block connector.
2) Tighten the wire-clamp screws.
3) Connect the power wires to suitable DC Switching type power supply. The input DC voltage should be in the
range of the spec.
Wiring the Power Input through PoE Injector
1) Install PoE injector power cord.
2) Install Ethernet cable between PoE ports of WA512G and PoE injector.
3) Install Ethernet cable between LAN ports of WA512G and PC/NB whenever proceeding
WebGUI configuration.
Wiring the Power Input through PSE switch
