Page
45
The procedure for changing the IP Address information is as follows:
1.
Use DHCP?
Check this box if your network has a DHCP server and you want
to use dynamic addressing. Otherwise, you must enter static IP address
entries in the four fields which follow.
2.
IP Address
:
Enter the network address. Leading zeroes are not required.
3.
IP Mask
: This should usually be 255.255.255.0 unless your network can
work across multiple subnets.
4.
Gateway Address
: This should usually be the same domain and subnet
address numbers as the IP Address, but with the last octet being .1.
5.
DNS-nameserver
: A default value is shown for reference only. DNS is not
normally required for basic static IP network configurations to work. Your IT
administrator will specify a value to work with mixed static/dynamic network
setups.
Save
: When you have made all of the necessary entries, press
Save
to apply the
changes internally before rebooting the unit.
System Setup
The
System Setup
page provides access to product information, licensing
information and entry, and AoIP card information. It actually consists of three
screens, selected by the
Product
,
Licenses
, and
AoIP Card
buttons. Figure 4-24
shows the screen produced when the
Product
button is clicked.
Figure 4–24: System Setup - Product
Most of the Product screen is informational. However, the
Preset/Config Lock
buttons allow you to Enable or Disable the front panel
Preset Config
button on the
