Page
13
are automatically connected together to allow the MADI signal to pass
through.
6.
MADI Fiber SFP
: (optional) This input module accepts an optical AES10
64-channel MADI input signal at 48 kHz sample rate. The SFP fiber
module may be used in conjunction with the MADI BNC connectors to
provide COAX to fiber or fiber to COAX conversion. The outputs are
reclocked. A software license must be installed for the SFP port to
function. Refer to the
System Setup
section in Chapter 4 and to Figure
4-8 to install software licenses.
7.
Dolby Metadata:
This output is not implemented at this time.
8.
AES Out:
By default, the BNC AES-1 jack outputs the
same mixed
audio
as the XLR analog outputs, as heard from speakers or headphones, but as
an AES3id pair. Other options may be set in the iAM-MIX Web GUI. AES
2-4 jacks may be used with Common Output Routing, a licensable feature
described in Chapter 4.
9.
AES In:
These four BNC jacks accept AES3id digital audio pairs at 48 kHz
sample rate.
Channels are selected as AES 1-8.
10.
SFP Module Cages
:
The two SFP cages
are
provided to accept one or
two
optional
SFP modules compatible with SDI coaxial or optical signals.
Single or dual transceiver arrangements are possible. The SFP modules
are swappable for convenience. The iAM-MIX must be powered off while
inserting an SPF module or else it must be power cycled after insertion.
An optional license key must be purchased to enable each module. A software
license must be installed for an SFP port to function. Refer to the
System
Setup
section in Chapter 4 and to Figure 4-8 to install software licenses.
The following SFP modules are offered:
a.
3G/HD/SD-SDI Single Video Receiver with Active Loopback
:
This uses HD-BNC connectors.
b.
3G/HD/SD-SDI Video SFP with Optical Input
: This uses LC
fiber connectors. It is a Single-Mode Receiver, Medium Haul, Non-
MSA, and no output.
c.
3G-SDI Transceiver
: This uses HD-BNC connectors. Input and
output are both SDI.
d.
SMTPE 2022-6 Receiver
: This uses Multi-Mode 850 NM, LC fiber
connectors. It allows the iAM-MIX to monitor SDI audio
transmitted in real time over Ethernet. You must use the emSET
configuration software to set up this option. It is available from
Wohler Technologies Technical Service.
e.
SMTPE 2110 Receiver
: This uses Multi-Mode 850 NM, LC fiber
connectors. It allows the iAM-MIX to monitor SDI audio
transmitted in real time over Ethernet. You must use the emSET
configuration software to set up this option. It is available from
Wohler Technologies Technical Service.
