821016: AMPx-E8 Series User Guide
© 2011 Wohler Technologies, Inc. All rights reserved.
58
Chapter 6
Setup Menu
Analog Output Preference Mode
To exit
Setup Mode
, press the
Esc
button.
Analog Output Preference Mode
To change the
Analog Output Preference
, select
AOutputPref
and
then press the
Enter
button.
This entry within the
Setup
menu is used to determine how the
Selected/Downmix Analog Out
and
Metered Analog Out
connectors on the rear panel output the metered signal when any of the
DM1, DM2, or DM3 downmix selections is enabled.
The default setting is
Downmix
, which outputs the speaker assign with
individual channel scaling (gain settings) intact as determined by the
selected downmix (DM1, DM2, or DM3). In addition, the channels are
summed at unity gain into the speakers and headphones. However, if
Discrete
is selected, then all channels within the downmix are output
from these connectors at unity gain without scaling of the channels as
determined by the selected downmix. For example, the center channel
scaling is -3dB, and the surround channel scaling is set in the
Setup
menu.
Recalling a Preset
1.
Press the
Fn + Setup
button to display the
Setup
menu.
2.
Press the
Up
button to display
RCallPSet
.
3.
Press the
Enter
button to select this option.
Note:
The
RCallSet
,
PSetMode
, and
ErasePSet
options will
not be available if a preset has not been previously saved to
the unit. See
Saving a Preset on page 59
for how to save a
preset of the current unit configuration.