821016: AMPx-E8 Series User Guide
© 2011 Wohler Technologies, Inc. All rights reserved.
28
Chapter 3
Audio Configuration
Analog Output Preference
Analog Output Preference
The Analog Output Preference determines how the
Selected/
Downmix Analog Output
connectors and the
Metered Analog
Output
connector output the metered signals when either the DM1,
DM2, or DM3 downmix options are selected. Refer to
Rear Panel
Connectors on page 14
for details.
The default setting is
Downmix
, which outputs the speaker assign with
individual channel scaling (gain settings) intact as determined by the
selected downmix. However, if you select
Discrete
, then all channels
with the downmix are output from these connectors at full gain
without
scaling of the channels as determined by the selected downmix.
To change the analog output settings:
1.
Hold the
Fn
button while pressing the
Setup
button.
2.
Press the
Down
button until the LCD screens
AOutPref
as shown
in
Figure 3–1
below.
Figure 3–1
Analog Output Preference LCD screen
3.
Pressing the
Enter
button displays either
Figure 3–2
or
Figure 3–3
depending on the current setting.
Figure 3–2
Analog Output Preference Setting -
Discrete
Figure 3–3
Analog Output Preference Setting -
Downmix
848131 3.03
Setup: AOut Pref
-- Setup --
Aout Pref: Discr
-- Setup --
Aout Pref: D-mix