821016: AMPx-E8 Series User Guide
© 2011 Wohler Technologies, Inc. All rights reserved.
23
Chapter 2
System Overview
Monitoring Inputs
Monitoring an Analog Input
1.
To monitor an analog signal, connect the analog input to the rear
panel
Balanced Analog In
(DB-25) connector.
2.
On the front panel, press the
Input
button until the LCD screen
displays
Analog
.
3.
Continue on to
Channel Selection and Mixing on page 25
.
Monitoring an AES Input
1.
To monitor an AES signal, do one or both of the following:
•
Connect an unbalanced AES signal to the rear panel
AES/
PCM In
1
(BNC), and/or
•
Connect a balanced AES signal to the rear panel
AES Bal In
& Loop Out
(DB-25).
2.
On the front panel, press the
Input
button until the LCD screen
displays the corresponding input you want to monitor:
•
AES1
for an unbalanced signal (connected to BNC 1).
•
AES2
for a balanced signal (connected to the DB-25).
3.
Refer to
Terminating/Unterminating Inputs on page 40
to check/
set your termination settings.
4.
Continue on to
Channel Selection and Mixing on page 25
.
Note:
For a complete description of each front panel control, refer
to
Front Panel Controls on page 8
.
For a complete description of each rear panel connector,
refer to
Rear Panel Connectors on page 14
.
Table 2–9
AES Input to Channel Relationship
AES BNC Connector
Channel Outputs
1
1 and 2
2
3 and 4
3
5 and 6
4
7 and 8