3.
Insert and push
an activated
mini SIM card
to the
SIM 1
titled tray (No. 4), top SIM
holder. Insert by following the hints of SIM card figure for the proper orientation. (The SIM
chip-side will be face down and the cutted edge towards to inside and push until it sleeves).
4.
If you are using an LTE450 module
than you need to insert the SIM card into the bottom
SIM 2
tray (No. 5). Orientation: the SIM chip will face up and the SIM title down.
5.
You can use the
micro-USB
(No. 3) connector with a
microUSB-to-USB cable connection as
USB LAN
- instead of the Ethernet connection.
6.
Beside / instead of USB connection you
can connect
an
UTP cable to the LAN1
(No. 6)
and/or
LAN2
(No. 7),
LAN3
(No. 8),
LAN4
(No. 9) RJ45 interface Ethernet port.
The other side of the UTP cable must be
plugged to your computer
or a network device
(hub or switch, if you are attempted to use one).
Note, that the Ethernet ports are bridged by default, which means its equal which port you
are using.
7.
By default, the data concentrator
has an installed OpenWRT
®
operating system which is
ready to use and configure to your SIM card APN and for you usage requirements.
8.
Plug
the
100-230V AC power
supply to power input
terminal block (No. 1), according the
pinout.
Current / power consumption
•
Power supply / Voltage range: ~100-230V AC, 50 Hz
•
Current: 0.1A at ~230V AC
•
Consumption: 3 - 15W
The following cables are not part of the accessories of the delivered package.
Use the following hints and the recommendation to choose useful cable and type to prepare
the necessary connection(s) according to your requirements.
