Chapter 2. Installing the device
2.1
The very first startup
The data concentrator has a super-capacitor component insidem, which can protect the device
against the possible short (<5sec) power outages. Therefore this component can be charged and it
can be exhausted after an outage or if you store the device for months without connecting power
source or using.
In these cases you cannot start the data concentrator as usual by adding the AC power supply only,
because only the
PWR
led will be active (lighing by
green
), but the device
won’t start
further.
First, you must start the data concentrator by the adding the power source and
pushing
the
Reset
button (No. 11) for
2 seconds
by a sharp object (e.g. by a pen)
–
while the
ON
led will be also
active (all the two leds are lighting by
green
colour)
–
then you can release the
Reset button
.
Then the device will start immediately and charging the supercapacitor (
SUPERCAPACITOR
CHARGE
led will be also active
–
by
yellow
colour).
