Next time you don’t need to push the
Reset
.
You can stop the device anytime by removing the power source and start the device by adding the
AC power on.
2.2
Normal startup
The data concentrator has a pre-installed system (which contains the firmware and the pre-
configured OpenWrt
®
system).
After adding power source to the device you will just need to configure some necessary and unique
settings for your SIM card, network access, and some other required connection parameters.
Please, start the data concentrator by the following sequence.
1.
If you are using 4G LTE module, insert an activated
SIM card
into
SIM
1
tray (No. 4) in the
right position. The usage of
SIM 1
holder is obligatory to use for wireless communication.
2.
If you are using LTE450 or Cat.M/Cat.NB module, insert active SIM card into SIM 2 titled
tray.
3.
Mount two antennas
to
the
Antenna
interfaces (No. 12 and 13).
4.
After plugging the
AC Power source
(No. 1), the device begins to perform booting
–
the
LED signals are always showing the current activity during the operation. The system start
needs about 40-50 seconds while it will be ready for usage, network communication.
5.
During the boot, the device begins to operate, whereas its LED signals are showing the
current activity during the operation.
6.
After adding power to the device, you need to set a few custom configuration parameters for
the SIM card, mobile network access, and other desired parameters. The device must be
turned on in the following order.
Boot sequence:
a.)
First the
LAN1
–
LAN4
leds are blinking for half a second, which signs that the power was
added. The
PWR
and
ON
leds are also active (lighing by
green
).
b.)
Then the
MBUS
and
RS485
LEDs are ligthing for ~10 seconds during the firmware start.