32
The
ROAMING
feature
enables
the roaming operation on the mobile network, which is
necessary to be also supported by the mobile operator of the SIM card. When you are
attempted to use the roaming, then you have to fill the value country code prefixes (e.g. the
+49 prefix for
Germany
in case of national usage or the 0049 prefix usage in case of
international useg – between foreign mobile operators through the roaming). Always be
informed about the international (roaming) usage conditions of the SIM card and cellular data
transmitting service – ask you mobile operator!
By the
REBOOTDAY
parameter you can
enable
the industrial- and safety standard daily once
device restart event.
The
IMPULSESENDFREQ
parameter means the transmitting frequency (in minutes) to
sending the counter data to the configured server IP.
rameter you can
enable
the industrial- and safety standard daily once device restart event.
The
PREFIX
parameter means that you can device an MQTT-alike device/project type
identifier prefix for the server for the better selection/identification of device (meter) type.
E.g. You can use e.g. the
meter1, meter2,
… or more complex identification like
m2m.metering.pulse.water1
or
m2m.metering.pulse.gas2
or any similar identifiers.
When you’ve changed one of the listed parameter values, then the program will highlight the
changed value lines by bold. For sending the listed parameter values for the device (regarding
the
Selected
coloumn) – check the proper selection – push the Write config button at the
bottom of the screen.
At the end of the parameter sending, the device is restarting by using the new settings.
In case of neccessary you can save the configuration to your computer by the Save file
button.
5.4 Test mode - Checking the incoming/readout signals
Choose the
Impulse
tab on the top of the screen to check the incoming impulse signals.
The
EasyTerm
®
will list the recepted and counted counter values of all connected inputs.
Here you can check the connection of the connected meter and can test the counted
impuse signals.
Important! The counting will be continous until the configured data transmitting interval
(the
IMPULSESENDFREQ
parameter).
