30
At the
APN
value, you have to define the APN name for the SIM-card related GPRS data
package service. When using a username or password are needed for the access – e.g. in case
of chap authentication – then define the
UN
and
PWD
values based on the information proven
by your mobile service provider.
PINCODE
can be also defined if it was requested by your mobile provider.
When you would like to use a DNS or DDNS server, you can allow it by the
DNS1
,
DNS2
)
parameters in the next format – e.g. wmsupport.dyndns.org
When you’ve changed one of the listed parameter values, then the program will highlight the
changed value lines by bold.
For sending the listed parameter values for the device (regarding the
Selected
coloumn) –
check the proper selection – push the Write config button at the bottom of the screen.
At the end of the parameter sending, the device is restarting by using the new settings.
5.2 Remote IP Server settings
In the IP Server Service parameter group, open the IP Server parameter group at the
Device Type
. Then the program will load the related parameters.
Check that the
GPRSEN
value is
Enabled
, which means that the device operating
as a wireless signaling transmitter.
Then at the
SERVER1
parameter fill the IP address of the IP address of your server and the
PORT1
value for the port number of the server.
