7
Voltage mode (WET)
o
Put the jumper on the IN1 or IN2 line’s 2-pins (two pair of pins), each pair
must be jumpered closer to the LED side – as you can see in the following
picture.
Signal levels (WET mode – voltage input):
Input high signal level:
8 - 24V
Input low signal level:
0 - 1V
Impulse signal frequency:
0 – 500Hz
When the input were activated (IN1, IN2) the INx titled LEDs are signing the active (high signal
level) status during the operation, with the proper light and colour. See
LED signals
part.
