Witt 24310037, Installation Advices - Instructions For The Use

Page: 17 / 52

17 17
Plug
Fig. 2.1a Fig. 2.1b
Right or left
inlet pipe
Manifold male
pipe fitting
Sealing
washer (#)
Plug (#)
1/2” G cylindrical
(EN ISO 228-1) male
1/2” G cylindrical
(EN ISO 228-1) female
(#) Already fitted on the right or
left inlet pipe
Fitting the plug on the unused
terminal of the gas inlet pipe
CONNECTING THE APPLIANCE TO THE GAS SUPPLY
The gas connection must be carried out by an authorised person according to the
relevant standards.
Ensure that the room in which the cooker is to be installed is adequately ventilated, in
compliance with applicable regulations.
•
Connect the cooker to the gas mains utilizing rigid or flexible pipes.
• The gas supply is connected at the rear of the cooker to the right or left terminal of the
gas inlet pipe (fig. 2.1a). The connection pipe must not cross the rear of the appliance.
• IMPORTANT NOTE: Before connecting the appliance to the gas mains fit the male
conical adaptor (if not already fitted on the inlet pipe, it is supplied with the appliance
in a separate kit) to the right or the left inlet pipe using the fibre washer supplied.
IMPORTANT: Check the correct positioning of the adaptor as per fig. 2.2 and
always operate using two suitable spanners.
• The unused inlet pipe must be closed off with the plug and sealing washer supplied
(fig. 2.1b).