Witt 24310037, Installation Advices - Instructions For The Use

Page: 22 / 52

22 22
ELECTRICAL SECTION
3
IMPORTANT: This appliance is to
be installed only by an authorised
person according to the current local
regulations and in observation of the
manufacturer’s instructions.
Incorrect installation, for which
the manufacturer accepts no
responsibility, may cause damage to
persons, animals and things.
• If the power supply cable is damaged
it must be substituted by a suitable
cable available in the after sales
service.
N.B. For connection to the mains,
do not use adapters, reducers or
branching devices as they can cause
overheating and burning.
If the installation requires alterations to the
domestic electrical system or if the socket
and appliance plug are incompatible, call
an expert.
He should also check that the socket
cable section is suitable for the power
absorbed by the appliance.
GENERAL
• Connection to the mains must be
carried out by qualified personnel in
accordance with current regulations.
• The appliance must be connected to
the mains checking that the voltage
corresponds to the value given in the
rating plate and that the electrical
cable sections can withstand the load
specified on the plate.
• The appliance is supplied without a
power supply plug and therefore if
you are not connecting directly to the
mains, a standardized plug suitable
for the load must be fitted.
• The plug must be connected to an
earthed socket in compliance with
safety standards.
• The appliance can be connected
directly to the mains placing an
omnipolar switch with minimum
opening between the contacts of 3
mm between the appliance and the
mains.
• The power supply cable must not
touch the hot parts and must be
positioned so that it does not exceed
75°C at any point.
• Once the appliance has been
installed, the switch or socket must
always be accessible.
The connection of the appliance to
earth is mandatory.
The manufacturer declines all
responsability for any inconvenience
resulting from the inobservance of
this condition.
Before effecting any intervention on
the electrical parts of the appliance,
the connection to the network must
be interrupted.