7-19
SECTION 7 –
PLUMBING
2. Turn Ice Maker Winterization Drain valve to
the OPEN position.
NOTE: Leave the Ice Maker Winterization
Drain valve in the OPEN position
throughout storage period.
3. Use an air compressor with pressure output of
30 psi to blow out drain lines.
4. After the last batch of ice dispenses, raise the
wire shut-off arm to the OFF position.
5. Empty ice bin.
To use Ice Maker again after seasonal
storage:
1. Close all drain valves.
2. Turn Ice Maker Winterization Drain valve to
the CLOSED position.
3. Turn the water supply ON.
4. Ensure the ice bin is in place and the wire shut-
off arm is lowered to the ON position.
5. Allow the refrigerator to cool down to ice
making temperature. Remember, this can take
up to 24 hours.
NOTE: Discard the first two batches of ice
cubes. It will take approximately three
cycles for the Ice Maker to produce fully
formed, clean ice cubes.
Winterizing Washer
–If Equipped
See the appliance manufacturer’s user guide
provided in your InfoCase for complete
winterizing instructions, operating instructions,
and safety precautions.
Ice Maker Drain Line
(Located in exterior Residential
Refrigerator service compartment)
Ice Maker Winterization Drain Valve
(Located in exterior Residential
Refrigerator service compartment)
