Printer configurations
Printers are shipped with all the functions and parameters pre-set at the
factory. Settings for various printer parameters can be changed. This menu
is printed on the receipt and scrolls through instructions for selecting and
changing user changeable functions or parameters.
When changing the paper type, you will need to either send the “Set paper
type” (1D 81 m n) command or use the “Set Paper Types” selection from the
configuration menu.
Be extremely careful changing any of the printer settings to avoid
inadvertently changing other settings that might affect the performance of
the printer.
The following functions and parameters can be changed in the scrolling
configuration menu (*except as noted):
n
Communication Interface
RS-232C se ri al in ter fa ce (25-pin)
Uni ver sal se ri al bus (USB)
Po we red USB
n
RS-232C serial interface settings
Baud rate
Data bits (*can not be chan ged)
Stop bits (*can not be chan ged)
Pa ri ty (*can not be chan ged)
Hard wa re (DTR/DSR) or soft wa re (XON/XOFF)
flow con trol
Data re cep ti on er rors
Al ter na te DTR/DSR
n
Diagnostic Modes
Nor mal
Da tas co pe
Re ceipt test
Slip test
Check flip test
n
Printer Emulations
TH420 na ti ve mode
PRINTER CONFIGURATIONS
32
