Wincor Nixdorf TH320, Programmer'S Manual

Page: 46 / 157

Programmers Guide TH320/420
38
Set right-side character spacing
ASCII ESC SP n
Hexadecimal 1B 20 n
Decimal 27 32 n
Range of n:
0- 32 (decimal)
Default: 0
Set the right side character spacing to [n x horizontal or vertical motion units]. Values for this command are
set independently in standard and paper mode.
The units of horizontal and vertical motion are specified by the set horizontal and vertical minimum motion
units (1D 50 …) command. Changes in the horizontal or vertical units do not affect the current right side
character spacing. When the horizontal or vertical motion unit is changed by the set horizontal and vertical
minimum motion units (1D 50 …) command the value must be in even units and not less than the minimum
amount of horizontal movement.
In standard mode the horizontal motion unit is used.
In page mode the horizontal or vertical motion unit differs and depends on the starting position of the
printable area. When the starting printing position is the upper left or lower right of the printable area
(set by select print direction in page mode, 1B 54 n) the horizontal motion unit (x) is used. When the
starting printing position is the upper right or lower left of the printable area (set by select print
direction in page mode, 1B 54 n) the vertical motion unit (y) is used.
The command can be enabled or disabled for the slip. Default is disabled for the slip on TH320, and
enabled on the model TH320 MICR France.
Select print mode
ASCII ESC ! n
Hexadecimal 1B 21 n
Decimal 27 33n
Value of n: Pitch selection (standard, compressed, double-high, or double-wide.)
Bit Function 0 1
Bit0 Pitch (See chart below) Standard pitch Compressed pitch
Bit3 Emphasized mode Canceled Set
Bit4 Double-high
2
Canceled Set
Bit5 Double-wide Canceled Set
Bit7 Underlined mode Canceled Set
Bits 1, 2 and 6 are not used.
1
Standard and compressed pitch cannot be used together in the same line.
Slip Default is standard pitch on TH320 and compressed pitch on model TH320 MICR France.
2
The double-high command can be enabled or disabled for the slip. Default is disabled for the slip on TH320, and enabled on the
model TH320 MICR France.
Select the print mode: standard, compressed, double-high, or double-wide.
Default:
00
Pitch Receipt Station Receipt CPI Slip Station Slip CPI
Standard 44 15.6 42 13.9
Compressed 56 20.3 51 17.1