Wincor Nixdorf TH320, Programmer'S Manual

Page: 150 / 157

Programmers Guide TH320/420
142
f = 2 link watermark printing
Example:
Activate watermark printing using logo #F1 (1F 03 16 02 s r ) with “ s ” being the skip
distance in dot rows before activation and “r ” is the distance in mm between atermark
repetitions.
After executing a knife-cut command and the f = 1 steps, if s > 0, execute the
following:
• skip “s” (feed paper) dot rows (15 s command)
• set watermark printing to “on” using logo F1 (execute merge watermark mode -1D
8C r F1 command). Logo must be defined for F1 and comply with watermark mode
requirements in order for this happen.
• stop background merging mode (1D 9B 1 command). Clears background for logos,
barcodes, and captured images.
The watermarks feature is now activated (following an optional F0 logo) to start after
each knife cut. Note that when printing graphic objects, merging is turned off by each
knife cut. The default value is s = 0 and turns off the f = 2 watermark link.
No correlation exists (when both are set) between watermark and logo skip distances.
If the f = 4 logo link is undefined, you should set a null trailer logo with s = 1 and p =
144 (1F 03 16 04 1 90, no logo at index F3). This will turn off watermarks at the
position of a knife cut and leave a clear space at the top of the next receipt.
f = 3 link margin message printing
Example:
Activate margin message printing using logo #F2 (1F 03 16 03 s r t) with “s” being the
skip distance, “r” the distance between repetitions and “t” the toggle mode.
Toggle mode values for t:
0 = both left and right side
1 = toggle sides, starting with left side
2 = right side margin message only
3 = left margin message only
After executing a knife cut command and the f=1 steps, if s > 0, execute the following:
• skip “s” dot rows (=15 s command). When both watermark and margin message
merging are defined, the respective “s” values are treated independently. The same
value should be used to start watermark and margin message at the same place.
• Use the toggle mode values listed above to apply margin message for the left and/or
right side. For a margin message on both sides, enter the 1D 99 1F2 p 0 command
followed by the 1D 99 t’ F2 r t’ (apply margin message) command with the logo at
index F2 defined.
• suspend background merging mode (=1D 9B 1 command), so any logos, barcodes,
and captured images will print in the clear The margin message printing feature is
activated after the header logo after a restart at each knifecut. Note that when printing
graphic objects, merging is turned off by each knife cut. No correlation exists (when
both are set) between watermark and logo skip distances. If the f = 4 logo link is
undefined, you should set a null trailer logo with s = 1 and p = 144 (1F 03 16 04 1 90,
no logo at index F3). This will turn off margin message at the position of a knife cut
and leave a clear space at the top of the next receipt.