Wincor Nixdorf TH320, Programmer'S Manual

Page: 32 / 157

Programmers Guide TH320/420
24
An incorrect setting of m n for a two-color paper or nonstandard monochrome paper, or failure to set m n
when a color paper is inserted will result in poor print quality
The last set paper type choice is stored in non-volatile memory and is retained after a power loss and
across reset commands. The initial value at first boot after firmware load (or reload) is
m n
=0 0.
Related information
An incorrect setting of
n
for a two-color paper or failure to set
n
when a two-color paper is loaded will
result in poor output quality.
Set interpretation of “Set current color” command
ASCII US ETX SYN ENQ n
Hexadecimal 1F 03 16 05 n
Decimal 31 03 22 05 n
Value of n:
0-FF (Hex)
n= 01 will cause 1B7201 to printed. Any other value for 1B72 will print black.
n= 00 will cause 1B7200 to printed and all other values to print black.
This command defines how to interpret the 1B 72 command for legacy environments. It provides a
method to resolve any differences in the definition of command 1B 72 between the TH320 native
mode and earlier implementations in other printers.
In TH320 native mode, the standard “Set current color” command should be used.
Related information
The 1F 03 16 00 command disables this and all other features.
To disable one feature when multiple features are set, first disable all features and then re-enable only
those you desire.
Print test form
ASCII AXt
Hexadecimal 1F 74
Decimal 31 116
Print the current printer configuration settings on the receipt. Disabled in page mode.