Wincor Nixdorf TH320, Programmer'S Manual

Page: 67 / 157

TH320/TH420 Programmers Guide
59

skip “s” dot rows (=15 s command). When both watermark and margin message merging
are defined, the respective “s” values are treated independently. The same value should be
used to start watermark and margin message at the same place.

Use the toggle mode values listed above to apply margin message for the left and/or right
side. For a margin message on both sides, enter the 1D 99 1F2
p 0 command followed by
the 1D 99 t’ F2 r t’ (apply margin message) command with the logo at index F2 defined.

suspend background merging mode (=1D 9B 1 command), so any logos, barcodes, and
captured images will print in the clear
The margin message printing feature is activated after the header logo after a restart at each knife-
cut. Note that when printing graphic objects merging is turned off by each knife cut. No correlation
exists (when both are set) between watermark and logo skip distances.
If the
f
= 4 logo link is undefined, you should set a null trailer logo with
s
= 1 and
p
= 144
(1F 03 16 04 1 90, no logo at index F3). This will save previous background merging value, so
logo prints in the clear

set centered justification (1B 61 1 command), saving the previous justification

if a logo at index F3h is currently defined, print the logo by sending print downloaded bit
image, normal size (1D 2F 0 command), without changing the value of current logo.

reset justification to previous value (1B 61 [previous value])

skip (feed paper)
“ p ”
dot rows (15
p
command) a minimum value of 90h, to ensure knife cut
occurs after the logo

restore background merge suspension (1D 9B [previous value])
Related information
This command is utilized in the WN utility. The utility can be used to pre-configure new printers with a
default colorization set-up without requiring any application changes. The default set-up was designed
to
Hexadecimal
1F 03 17 a m s
Decimal 31 03 23 a m s
Values: a = attribute map selector turn off attribute
a , m, s = 0, 0, 0 (all 3 bytes required) selects first attribute mapping
definition
a = 1 mapping definition (of two available) selects
a = 2 second attribute
a = 1 or 2, if m = 0 mapping 1 or 2, respectively, is turned off
A word (2 bytes) is used to identify the attribute mapping, with
“ m ”
bits 0 – 6 identifying which original
attributes should be mapped:
turn off margin message at the position of a knife cut and leave a clear space at the top of the next
receipt.
f = 4 link logo print before cut
Prints a logo after the skip distance of
“ s ”
before a logo and
“ p ”
past a logo and performs a knife cut
(1F 03 16 04
s p ) .
Immediately before executing a knife-cut command, if
s
> 0, execute the following:

skip (feed paper)
“ s ”
dot rows (15
s
command)

stop background merging (1D 9B 1 command).
Provide a general level of colorization features that would not affect the printer operation. You can
expand beyond the default features of the utility by modifying the application at the host. However,
do not attempt to modify the settings within the utility.