Wincor Nixdorf TH320, Programmer'S Manual

Page: 96 / 157

Programmers Guide TH320/420
88
Select standard mode
ASCII ESC S
Hexadecimal 1B 53
Decimal
27 83
Switch from page mode to standard mode. In switching from page mode to standard mode, data buffered
in page mode are cleared, the printing area set by set print area in page mode (1B 57) is initialized
and the print position is set to the beginning of the line.
This command switches the settings for the following commands (the values for these commands can
be set independently in standard mode and page mode) to those for standard mode:

Set right-side character spacing (1B 20)

Select 1/6 inch line spacing (1B 32)

Set line spacing (1B 33)
Standard mode is automatically selected when power is turned on, the printer is reset, or the initialize
printer command (1B 40) is used.
Exceptions
This command is effective only in page mode.
Select print direction in page mode
ASCII ESC T n
Hexadecimal 1B 54 n
Decimal
27 84 n
Value of n:
Start position
0 = Upper left corner proceeding across page to the right (A)
1 = Lower left corner proceeding up the page (B)
2 = Lower right corner proceeding across page to the left (upside down) (C)
3 = Upper right corner proceeding down page (D)
Default: 0
Select the printing direction and start position in page mode.
The command can be sent multiple times so that several different print areas, aligned in different print
directions, can be developed in the printer’s page buffer before being printed using the print page
mode commands (0C or 1B 0C).
On the slip, the default page size (depth) provides a print area about ten inches deep. This is
equivalent to a rotated check about 120 columns wide by 17 lines high, or 21 lines high compressed
Exceptions
The command is valid only in page mode.
The command is ignored if the value of n is out of the specified range.