Wincor Nixdorf TH200, Programmer'S Manual

Page: 42 / 106

Programmer’s Guide
TH200
42
Reference:
Example:
with the number of NV bit images specified by command FS p .

A definition data of a NV bit image consists of [xL xH yL yH d1...dk]. Therefore, when
only one NV bit image is defined n=1, the printer processes a data group [xL xH yL yH
d1...dk] once. The printer uses ([data: (xL + xH × 256) × (yL + yH × 256) × 8] +
[header:4]) bytes of NV memory.

The definition area in this printer is a maximum of 1M bits (128K bytes). This command
can define several NV bit images, but cannot define a bit image data whose total
capacity [bit image data + header] exceeds 1M bytes (128K bytes).

The printer is busy immediately before writing into NV memory.

When this command is received during macro definition, the printer ends macro
definition, and begins performing this command.

Once a NV bit image is defined, it is not erased by performing ESC @ , reset, and power
off.

This command performs only definition of a NV bit image and does not perform printing.
Printing of the NV bit image is performed by the FS p command.
FS p
When xL = 64, xH = 0, yL = 96, yH = 0