Wincor Nixdorf TH200, Programmer'S Manual

Page: 64 / 106

Programmer’s Guide
TH200
64
GS v 0 m xL xH yL yH d1....dk Print raster bit image
Code:
Range:
Description:
Notes:
Example:
ASCII GS v 0 m xL xH yL yH d1...dk
Hex 1D 76 30 m xL xH yL yH d1...dk
Decimal 29 118 48 m xL xH yL yH d1...dk
0
≤
m
≤
3, 48
≤
m
≤
51
0
≤
xL
≤
255
0
≤
xH
≤
255
0
≤
yL
≤
255
0
≤
d
≤ 255
k = (xL + xH × 256) × (yL + yH × 256) (k
≠
0)
Selects Raster bit-image mode. The value of m selects the mode, as follows:
m Mode Vertical Dot Density
(DPI)
Horizontal Dot Density
(DPI)
0, 48 Normal 180 DPI 203 DPI
1, 49 Double-width 180 DPI 101 DPI
2, 50 Double-height 90 DPI 203 DPI
3, 51 Quadruple 90 DPI 101 DPI

xL, xH, select the number of data bytes (xL+ xH × 256) in the horizontal direction for the
bit image.

yL, yH, select the number of data bytes (yL+ yH × 256) in the vertical direction for the bit
image.

In standard mode, this command is effective only when there is no data in the print
buffer.

This command has no effect in all print modes (character size, emphasized,
double-strike, upside-down, underline, white/black reverse printing, etc.) for raster bit
image.

Data outside the printing area is read in and discarded on a dot-by-dot basis.

The position at which subsequent characters are to be printed for raster bit image is
specified by HT (Horizontal Tab), ESC $ (Set absolute print position), ESC \ (Set
relative print position), and GS L (Set left margin ). If the position at which subsequent
characters are to be printed is not a multiple of 8, print speed may decline.

The ESC a (Select justification) setting is also effective on raster bit images.

When this command is received during macro definition, the printer ends macro
definition, and begins performing this command. The definition of this command should
be cleared.

d indicates the bit-image data. Setting a bit to 1 prints a dot and setting it to 0 does not
print a dot.
When xL+ xH × 256 = 64