Wincor Nixdorf TH200, Programmer'S Manual

Page: 33 / 106

Programmer’s Guide
TH200
33
ESC c 3 n Select paper sensor(s) to output paper end signals
Code:
Range:
Description:
Notes:
Default:
ASCII ESC c 3 n
Hex 1B 63 33 n
Decimal 27 99 51 n
0
≤
n
≤
255
Selects the paper sensor(s) to output paper end signals
Each bit of n is used as follows:
Bit Off/On Hex Decimal Function
Off 00 0 Paper roll near-end sensor disabled 0
On 01 1 Paper roll near-end sensor enabled
Off 00 0 Paper roll near-end sensor disabled 1
On 02 2 Paper roll near-end sensor enabled
2-7 Undefined

It is possible to select multiple sensors to output signals. Then, if any of the sensors
detects a paper end, the paper end signal is output.

The command is available only with a parallel interface and is ignored with a serial
interface.

Sensor is switched when executing this command. The paper end signal switching be
delayed depending on the receive buffer state.

If either bit 0 or bit 1 is on, the paper roll near-end sensor is selected as the paper
sensor outputting paper-end signals

When all the sensors are disabled, the paper end signal always outputs a paper present
status.
n = 15
ESC c 4 n Select paper sensor(s) to stop printing
Code:
Range:
Description:
Notes:
ASCII ESC c 4 n
Hex 1B 63 34 n
Decimal 27 99 52 n
0
≤
n
≤
255
Selects the paper sensor(s) used to stop printing when a paper-end is detected,
using n as follows:
Bit Off/On Hex Decimal Function
Off 00 0 Paper roll near end sensor disabled 0
On 01 1 Paper roll near end sensor enabled
Off 00 0 Paper roll near end sensor disabled 1
On 02 2 Paper roll near end sensor enabled
2-7 Undefined

When a paper sensor is enabled with this command, printing is stopped only when the
corresponding paper is selected for printing.

When a paper-end is detected by the paper roll sensor, the printer goes off-line after