Wincor Nixdorf TH200, Programmer'S Manual

Page: 70 / 106

Programmer’s Guide
TH200
70

In the JIS code system, the following codes are available:
Primary byte: <21>H to <7E>H
Secondary byte: <21>H to <7E>H

In the SHIFT JIS code system, the following codes are available:
Primary byte: <81>H to <9F>H and <E0>H to <EF>H
Secondary byte: <40>H to <7E>H and <80>H to <FC>H
FS S n1 n2
Set left- and right-side Kanji character spacing
Code:
Range:
Description:
Notes:
Default:
Reference:
ASCII FS S n1 n2
Hex 1C 53 n1 n2
Decimal 28 83 n1 n2
0
≤
n1
≤
255
0
≤
n2
≤
255
Sets left-side and right-side Kanji character spacing n1 and n2, respectively.

When the printer model used supports GS P , the left-side character spacing is [n1 ×
horizontal or vertical motion units], and the right-side character spacing is [n2 ×
horizontal or vertical motion units].

When double-width mode is set, the left- and right-side character spacing is twice the
normal value.

The horizontal and vertical motion units are set by GS P . The previously specified
character spacing does not change, even if the horizontal or vertical motion unit is
changed using GS P .

In standard mode, the horizontal motion unit is used.

In page mode, the horizontal or vertical motion unit differs in page mode, depending on
starting position of the printable area as follows:
①
When the starting position is set to the upper left or lower right of the
printable area using ESC T , the horizontal motion unit (x) is used.
②
When the starting position is set to the upper right or lower left of the
printable area using ESC T , the vertical motion unit (y) is used.
③
The maximum right-side spacing is 288/203 inches for the paper roll and is
approximately 36 mm {288/203 inches}. Any setting exceeding the
maximum is converted to the maximum automatically.
n1 = 0, n2 = 0
GS P