Wincor Nixdorf TH200, Programmer'S Manual

Page: 23 / 106

Programmer’s Guide
TH200
23
ESC 3 n Set line spacing
Code:
Range:
Description:
Notes:
Default:
Reference:
ASCII ESC 3 n
Hex 1B 33 n
Decimal 27 51 n
0
≤
n
≤
255
Sets the line spacing to [n × vertical or horizontal motion unit] inches.

The line spacing can be set independently in standard mode and in page mode.

The horizontal and vertical motion units are specified by GS P . Changing the horizontal
or vertical motion unit does not affect the current line spacing.

In standard mode, the vertical motion unit (y) is used.

In page mode, this command functions as follows, depending on the starting position of
the printable area:
①
When the starting position is set to the upper left or lower right of the
printable area using ESC T , the vertical motion unit (y) is used.
②
When the starting position is set to the upper right or lower left of the
print able area using ESC T , the horizontal motion unit (x) is used.

The maximum paper feed amount is 1016 mm (40 inches). Even if a paper feed amount
of more than 1016 mm (40 inches) is set, the printer feeds the paper only 1016 mm (40
inches).
Line spacing equivalent to approximately 4.23mm (1/6 inches).
ESC 2 , GS P
ESC = n
Set peripheral device
Code:
Range:
Description:
Notes:
Default:
ASCII ESC = n
Hex 1B 3D n
Decimal 27 61 n
0
≤
n
≤
1
Selects device to which host computer sends data, using n as follows:
Bit Off/On Hex Decimal Function
Off 00 0 Printer disabled 0
On 01 1 Printer enabled
1-7 Undefined
When the printer is disabled, it ignores all data except for error-recovery commands (DLE
EOT, DLE ENQ, DLE DC4 ) until it is enabled by this command.
n = 1