Wincor Nixdorf TH200, Programmer'S Manual

Page: 34 / 106

Programmer’s Guide
TH200
34
Default:
printing stops.

When either bit 0 or 1 is on, the printer selects the paper roll near-end sensor for the
paper sensor to stop printing.
n = 0
ESC c 5 n
Enable/disable panel button
Code:
Range:
Description:
Notes:
Default:
ASCII ESC c 5 n
Hex 1B 63 35 n
Decimal 27 99 53 n
0
≤
n
≤
255
Enables or disables the panel button.

When the LSB of n is 0, the panel button is enabled.

When the LSB of n is 1, the panel button is disabled.

Only the lowest bit of n is valid.

When the panel button is disabled, it is not usable when the printer cover is closed.

In this printer, the panel button is the FEED button.

In the macro ready mode, the FEED button is enabled regardless of the settings of this
command; however, the paper cannot be fed by using this button.
n = 0
ESC d n
Print and feed n lines
Code:
Range:
Description:
Notes:
Reference:
ASCII ESC d n
Hex 1B 64 n
Decimal 27 100 n
0
≤
n
≤
255
Prints the data in the print buffer and feeds n lines.

This command sets the print starting position to the beginning of the line.

This command does not affect the line spacing set by ESC 2 or ESC 3 .

The maximum paper feed amount is 1016 mm (40 inches). If the paper feed amount (nx
line spacing) of more than 1016 mm (40 inches) is specified, the printer feeds the paper
only 1016 mm (40 inches).
ESC 2 , ESC 3