Winbook SI, User Manual

Page: 122 / 216

7. To install the new memory card, hold the card with its gold edge
connector toward the edge connector slot of the compartment. In order
to help you orient the cards, the edge connector has been made with
two unequal-length sections. The longer section should be placed
toward the front end of the machine.
8. Holding the card at a shallow angle, insert the edge connector
into the slot. When the card is fully inserted, the gold edge connector
should not be visible.
9. Press the card downward until it is flat. You should hear an
audible click as the latches of the connector secure the card in place.
10. Once the module is properly seated, you can replace the cover on
this compartment. On the bottom of the cover there are small clips
that slide into place. Line up the clips with the slots along the edges
of the compartment and insert the cover into place. Slide the cover
toward the center of the machine until the hole in the cover lines up
with the screw hole in the unit.
11. Replace and tighten the screw.
12. Turn the unit over and restart the computer. Your WinBook notebook
should automatically register the new memory. If the memory size
indicated during the POST (Power On Self Test) that appears when you
boot does not match your new memory configuration, retrace the steps
of the installation to be certain that the SO-DIMM modules are proper-
ly installed.
Series
User’s Manual
7.6
Si Series Manual 2/18/00 4:09 PM Page 124