Wilson Electronics The Duette, Owner'S Manual, Page: 31 / 81

s
e C t i O n
3 – D
u e t t e i n a
b
O O k s h e l f
1
W i l s o n A u d i o S p e c i a l t i e s
this may result in damage to the binding post and/or the resistor leads. See Figure 6.
Section 3.3 – Alignment Cones
Note: Refer to the instructions on page
49 that describe the safe procedure in
removing the protective film from the
Duettes. Remove the film at this time.
There are three embedded magnets
each on the bottom, left, and right sides
of the Duette. Two are located near the
front and one near the back of the Duette
on each of these three sides. The mag -
nets are embedded beneath the painted
surface and are not visible (See Figure 7).
This Magnepod™ (patent pending) attach -
ment system allows the cones to be se -
cured without additional hardware.
Your installation kit contains three
cone sizes for geometric alignment tun -
ing, labeled “A,” “B,” and “C.” The code,
which reflects size, is stamped into the
base of each cone. Using the above chart (page 25), determine the cone combination
that is appropriate for your installation. Remove the six cones from the installation kit.
Locate and remove the six brass discs, the round cone gaskets, and the putty from
your setup kit. Prepare six pea-sized balls of the putty. Press the putty onto the center
of each brass disc, compressing it to 1/4 inch (5mm) circle over the cone indent. Push
the cone point into the putty until it seats in the brass disc indent. The putty will keep
the cone and the brass disc together. Place the cone/disc assembly onto the bottom (or
f
igure
7 - m
agnepoDS are locateD on Both
SiDeS aS well aS the Bottom of the
D
uette
�
m
agnepoD
l
ocationS