Wilson Electronics The Duette, Owner'S Manual, Page: 16 / 81

Section 2.1 – Configuring the Du-
ette for Installation
Installing the Tweeter Resistor
The Duette’s tuning resistor, locat -
ed on the rear of the Novel crossover, is
one key to optimizing the performance
of your Duettes.
Note: This resistor is not installed prior
to shipping and must be installed be-
fore the Duette is connected.
If your Duettes are being installed
near the wall, install the 4.2-ohm re -
sistor into your Novel Crossover (See
Figure 1). If your Duettes are being
installed more than 24 inches (.66 me -
ters) from the walls, install the 5.3-ohm
resistor into your Novel Crossover (See
Figure 1).Secure the resistor to the rear
of the Novel crossover to the binding
post labeled “Tweeter Resistor.” Tight -
en the binding posts just enough so the
resistor remains in place.
Locate the small resistor Allen
screw. Loosen either binding post and
position the metal tab of the resis -
tor over the threaded holes. Carefully
D
u e t t e
O
w n e r
’
s
M
a n u a l
16
W i l s o n A u d i o S p e c i a l t i e s
f
igure
1 - i
nStall the correct reSiStor to the top
BinDing poStS on the rear of the
n
ovel
c
roSSover
�