Wilson Electronics The Duette, Owner'S Manual, Page: 30 / 81

Section 3.2
–
Installing the
Tweeter Resistor
Duettes on Shelving Units Near Solid
Walls
Note: the Duette’s tuning resistor,
located on the rear of the Novel
crossover, is one key to optimizing
the performance of your Duettes.
This resistor is not installed prior to
shipping and must be installed be-
fore the Duette is connected.
Locate the 4.2-ohm resistor in
your Duette installation kit. Finger
tighten the resistor to the top bind -
ing posts on the rear of the Novel
crossover labeled “Tweeter Resistor.”
Tighten the binding posts just enough
so the resistor remains in place.
Locate the small Allen screw.
Loosen one of the binding posts and
position the metal eye of the resistor
over the threaded holes. Carefully
thread the Allen screw through the
resistor’s tab and into the threaded
hole so the resistor is snug against
the rear plate.
Tighten the binding posts so that
they are snug. Do not over tighten as
D
u e t t e
O
w n e r
’
s
M
a n u a l
0
W i l s o n A u d i o S p e c i a l t i e s
f
igure
6 - i
nStall the
4�2-
ohm reSiStor to the top
BinDing poStS on the rear of the
n
ovel
c
roSSover
�