Wilson Electronics The Duette, Owner'S Manual, Page: 20 / 81

D
u e t t e
O
w n e r
’
s
M
a n u a l
0
W i l s o n A u d i o S p e c i a l t i e s
Installing the Duette Stand Spikes
After carefully optimizing the
location of the stand-mounted Duet -
tes in the room, define the position
of the Duettes using masking tape by
marking the edge around the base of
the stand. This will enable you to re -
turn your Duettes to their final setup
location after you install the stand
spikes. Remove the Duette and Novel
crossover from the stand.
Tip the stand on its end and
insert spikes into the threaded holes
on the underside of the lower stand
plate. Leave the spike nuts loose at
this time. Return the stand to its po -
sition marked by the tape and re-in -
stall the Duette and the Novel cross -
over.
Leveling the Duette Stand
• Place a level on the left to right oriented axis in the top of the Duette
stand.
• If the bubble shows that the speaker is leaning toward the center of the
room, you will have to lengthen one of the inside spikes down toward the
floor. If the bubble is leaning toward the outside of the room, you will
have to lengthen one of the outside spikes down toward the floor.
f
igure
5 - i
nStall the StanD SpikeS anD nutS into the
threaDeD hole on the Bottom of the StanD plate
�