Wilson Electronics The Duette, Owner'S Manual, Page: 17 / 81

install the Allen screw so that the resistor is
snug against the rear plate.
Tighten the binding posts so that they
are snug. Do not over tighten as this may
result in damage to the binding post and/or
the resistor leads. See Figure 1.
Section 2.2 – Installing the Duette on
a Stand
Note: Refer to the instructions on page 49
that describe the safe procedure in remov-
ing the protective film from the Duettes.
Remove the film at this time.
Installing Brass Disc Receptacles in Du-
ette Stand
Install the three brass discs into
the machined recesses located on of
the stand top plate. Make sure that the
inverted cone detent of the brass disc
faces up. See Figure 2.
Locate the putty in your setup kit.
Prepare six pea-sized balls of the putty.
Press the putty onto the center of each
brass disc, compressing it to a 1/4 inch
s
e C t i O n
2 – D
u e t t e O n a
s
t a n D
17
W i l s o n A u d i o S p e c i a l t i e s
f
igure
3 - t
he geometric coneS are SecureD via
m
agnepoDS emBeDDeD in the
D
uette
�
f
igure
2 - i
nStall the three BraSS DiScS in the
circular receSSeS on the top of the StanD
�