Wilo STRATOS GIGA, Installation And Operating Instructions Manual

Page: 72 / 265

English
72 WILO SE 03/2018
2.2 Personnel qualifications The installation, operating and maintenance personnel must have the
appropriate qualifications for this work. Area of responsibility, terms
of reference and monitoring of the personnel are to be ensured by the
operator. If the personnel are not in possession of the necessary
knowledge, they must be trained and instructed. This can be carried
out, if necessary, by the product manufacturer at the operator’s
request.
2.3 Danger in the event of
non-observance of the safety
instructions Non-observance of the safety instructions can result in the risk of
injury to persons and damage to the environment and the product/
unit. Non-observance of the safety instructions will lead to the loss of
any claims to damages.
In particular, non-observance can, for example, result in the following
risks:
• danger to persons due to electrical, mechanical and bacteriological
factors,
• damage to the environment due to leakage of hazardous materials,
• material damage,
• failure of important product/unit functions, and
• failure of required maintenance and repair procedures.
2.4 Safety consciousness on the job The safety instructions included in these installation and operating
instructions, the existing national regulations for accident preven-
tion, together with any operator’s internal working, operating and
safety regulations are to be complied with.
2.5 Safety instructions for the operator This device is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or who lack
experience and knowledge, unless they have been given supervision
or instruction concerning the use of the device by a person responsi-
ble for their safety.
Children should be supervised to ensure that they do not play with the
device.
• If hot or cold components on the product/unit lead to hazards, meas-
ures must be taken by the customer to prevent them from being
touched.
• Guards protecting against touching moving components (such as the
coupling) must not be removed whilst the product is in operation.
• Leakages (e.g. from a shaft seal) of hazardous fluids (e.g. explosive,
toxic or hot) must be conveyed away so that no danger to persons or
to the environment arises. National statutory provisions must be
observed.
• Highly flammable materials should always be kept a safe distance
from the product.
• Danger from electrical current must be eliminated. Local directives or
general directives [e.g. IEC, VDE etc.] and instructions from local
energy supply companies must be adhered to.
2.6 Safety instructions for installation
and maintenance work The operator must ensure that all installation and maintenance work
is carried out by authorised and qualified personnel, who have
obtained sufficient knowledge by reading the operating instructions.
Work on the product/unit must only be carried out when it is at a
standstill. The procedure described in the installation and operating
instructions for shutting down the product/unit must be strictly
observed.
Immediately upon completing work, all safety and protective devices
must be put back in position and/or recommissioned.