Wilo STRATOS GIGA, Installation And Operating Instructions Manual, Page: 107 / 265

English
Installation and operating instructions Wilo-Stratos GIGA, GIGA-D, GIGA B
(11-22kW)
107
5.2.1.0 LON/CAN/IF
module
Wink/service The wink function permits the
identification of a device in the
BMS network. A “wink” is
executed by confirmation. Only displayed when LON,
CAN or IF module is active
5.2.2.0 Local/remote
operation BMS local operation Temporary state, automatic
reset to remote operation
after 5 min
BMS remote operation
5.2.3.0 Bus address Setting of bus address
5.2.4.0 IF gateway val A
Specific settings of the IF
module, depends on protocol
type
Further information can be
found in the installation and
operating instructions of the
IF modules
5.2.5.0 IF gateway val C
5.2.6.0 IF gateway val E
5.2.7.0 IF gateway val F
5.3.0.0 In1 (sensor input) Settings for sensor input 1 Not displayed in
constant speed mode
(incl. all sub-menus)
5.3.1.0 In1 (sensor value
range) Display of sensor value range 1 Not displayed with
PID-Control
5.3.2.0 In1 (value range) Setting of the value range
Possible values: 0...10 V/2...10 V/
0...20 mA/4...20 mA
5.4.0.0 In2 Setting for external setpoint
input 2
5.4.1.0 In2 active/inactive ON
External setpoint input 2 active
OFF
External setpoint input 2
inactive
5.4.2.0 In2 (value range) Setting of the value range
Possible values: 0...10 V/
2...10 V/0...20 mA/4...20 mA Not displayed when
In2 = inactive
5.5.0.0 PID parameters Settings for PID-Control Only displayed when
PID-Control is active
(incl. all sub-menus)
5.5.1.0 P parameter Setting of the proportional term
of the control
5.5.2.0 I parameter Setting of the integral term of
the control
5.5.3.0 D parameter Setting of the derivative term of
the control
5.6.0.0 Error Settings for behaviour in the
event of a fault
5.6.1.0 HV/AC HV “heating” mode
AC “cooling/air-conditioning”
mode
No. Designation Type Symbol Values/explanations Display conditions
±
±
±
±
±
±
±
±
±
±
±
±
±
±