Basics and Assembly
8
Wieland Electric GmbH | BA000941 | 01/2014 (Rev. A)
3
Basics and Assembly
The focus of this chapter is on the introduction of the Wieland system
ricos
FLEX. Here
you will find the information required to assemble and wire a controller system consisting
of System
ricos
FLEX components.
Besides the dimensions the general technical data of system
ricos
FLEX will be found.
3.1
System conception
System
ricos
FLEX is a modular automation system for assembly on a 35 mm mounting
rail. By means of the peripheral modules with 2, 4 or 8 channels this system may properly
be adapted matching to your automation tasks.
The wiring complexity is low, because the supply of the DC 24 V power section is
integrated to the backplane bus and defective modules may be replaced with standing
wiring.
By deployment of the power modules in contrasting colors within the system, further
isolated areas may be defined for the DC 24 V power section supply, respectively the
electronic power supply may be extended with 2 A.
The system
ricos
FLEX consists of the following components:
•
Bus coupler
•
Periphery modules
•
Power modules
•
Accessories
Bus coupler
With a bus coupler bus interface and
power module is integrated to one casing.
With the bus interface you get access to a
subordinated bus system.
Via the integrated power module for power
supply the bus interface is supplied as well
as the electronic of the connected
extension modules.
The DC 24 V power section supply for the
linked extension modules is established via
a further connection at the power module.
By installing of up to 64 extension modules
at the bus coupler, these are electrically
connected, this means these are assigned
Overview
Components
