All information, illustrations and specifications in this manual are based on the latest information
available at the time of publication. We reserve the right to make changes at any time without notice.
28
6.0. Before Operation
6.5. Setting the number of holes
NOTE
The number of holes (per
tine and minute) depends on:
•
The speed of the tractor‘s
power take-off shaft,
•
The chosen gear speed,
(lever (A) in gear
speed III in photo).
For 20mm (3/4“9 or 25 mm (1“)
tines use gear I and II only!
If the hole distance is
too small:
•
Increase the driving
speed, or
•
Decrease the speed of the
power take-off shaft.
If the hole distance is too wide:
•
Lower driving speed or
•
raise up PTO shaft.
Speed of power take-off = number of holes per tine:
Gear speed
300 350 400 450 500 540
I
97 113 130 146 162 175
II
129 150 172 193 215 232
III
161 188 215 242 269 290
Speed of Power Take-off Shaft (rpm)
