Whirlpool WED99HEDC0, Technical Education

Page: 65 / 100

COMPONENT ACCESS
HybridCare™ Dryer with Heat Pump Technology
n
4-17
To Remove the High Limit Thermostat
1. Unplug dryer or disconnect power.
2. Remove drain hose from standpipe or laundry tub.
3. Perform the procedures on page 4-15, “Removing the
Rear Panel” prior to performing the following steps.
Heater
Aux. Fan
High-Limit
Thermostat
Drain Port
Figure 1
4. Disconnect the two terminal wires from the high limit
thermistor (see Figure 2).
5. Remove the two (2) 1/4” hex-head screws securing the
thermistor to the inlet duct (see Figure 2).
Disconnect
thermistor
terminals
Remove
2 screws
Figure 2
Removing the High Limit and Auxiliary Fan
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Failure to do so can result in death or
electrical shock.
Replace all parts and panels before operating.
To Remove the Auxiliary Fan
1. Unplug dryer or disconnect power.
2. Remove drain hose from standpipe or laundry tub.
3. Perform the procedures on page 4-15, “Removing the
Rear Panel” prior to performing the following steps.
Heater
Aux. Fan
High-Limit
Thermostat
Drain Port
Figure 3
4. Disconnect the fan connector (yellow wires) as illustrated
in Figure 4.
5. Remove the two (2) 1/4” hex-head screws securing the fan
to the fan bracket (see Figure 4). Remove the fan assembly.
Remove
2 screws
Disconnect
Fan Connector
Figure 2
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Failure to do so can result in death or
electrical shock.
Replace all parts and panels before operating.