28
| CLEANING AND SANITIZING YOUR VESSI™ FERMENTOR & DISPENSER
14
Replace the base lid�
Base lid
PRESSURE/LEAK TESTING
1
Remove the 8" stainless steel cap,
gasket, and tri-clamp and add
15-20 oz of sanitizer liquid to the
vessel� Replace the 8" stainless
steel cap, gasket, and tri-clamp�
2
Turn the 3-way valve knob to the
PRESSURIZE VESSEL position
until the console pressure gauge
reads 10 psi� Turn the 3-way valve
knob to OFF�
3
Insert the SRS handle and turn
180° to the end of the groove to
allow sanitizing liquid to dispense
into the purge tank�
Turn the handle back to the
original position�
NOTE: The groove may be on
the left or right and the stopper
may be on the top or bottom,
depending upon your assembly�
This is normal�
Groove
Stopper
SRS handle
4
Check for any liquid leaking from
the SRS�
If there are no leaks:
Continue turning the handle back
and forth until all sanitizer has
been removed from the system�
Open the faucet to release all CO
2
pressure from the vessel�
If there are leaks:
Drain all of the sanitizer through the
faucet� Leave the faucet open to
release all CO
2
pressure from
the vessel�
Remove and disassemble the
SRS� Reassemble, following
the procedure in the “Sediment
Removal System (SRS) Assembly”
section, then repeat steps 2 and
3 again�
CLEANING AND SANITIZING YOUR VESSI™
FERMENTOR & DISPENSER
