Whirlpool duet GEW9200L Series, Job Aid

Page: 60 / 68

6-2
KEYPAD TEST
1. Press the Dryness Level keypad.
The three Dryness Level LEDs should
turn off and the dryer should beep.
2. Press the Control On keypad.
The Control Locked LED should turn off.
3. Turn the cycle selector knob one complete
rotation.
When the knob points to a cycle, the
corresponding LED should go out, and the
dryer should beep. When the knob is point-
ing in the large spaces between the
Manual
and Automatic cycle groups, only a beep
should be heard.
4. Touch the More Time keypad.
The most significant “ 8 ” should turn off and
the dryer should beep.
5. Touch the Less Time keypad.
The least significant “ 8 ” should turn off and
the dryer should beep.
6. Touch the Wrinkle Shield keypad.
The corresponding LED should turn off
and the dryer should beep.
7. Touch the Temperature keypad.
The five Temperature Level LEDs should
turn off and the dryer should beep.
8. Touch the End Of Cycle Signal keypad.
The three End Of Cycle level LEDs should
turn off and the dryer should beep.
ADDITIONAL TESTS
1. Open the dryer door.
The dryer should beep and the display will
show a number, followed by a capital “
E ”
for electric models, or a lower case “ g ” for
gas models. The first number will be a 3
(Whirlpool access).
2. Touch the Sensing keypad.
The dryer should beep while touching the
keypad and the display will show a 2-digit
software revision code.
3. Close the dryer door.
The display should turn blank.
4. Touch the Start keypad.
The Status LEDs should turn off, the heater
and motor should turn on, and the display
should read a 2-digit project ID code.