Whirlpool duet GEW9200L Series, Job Aid

Page: 23 / 68

2-13
Install
These 6
Screws
Hole Plug
6. Install a screw halfway into the second
hole from the top.
7. Hang the door hinge on the screw you just
installed, then install the remaining four
screws in their holes, and tighten the loose
screw securely. Make sure that all five
hinge screws are secure.
INSTALL THE NEW HANDLE
FILLER AND HINGE COVER
1. Using the new handle filler that was pro-
vided with the reversing kit, hook the top of
the handle filler onto the loosened upper
door trim, and snap the joined pieces into
place.
2. Hook the bottom of the handle filler onto
the lower door trim and snap it into place.
3. Repeat steps 1 and 2 to install the hinge
cover on the opposite side of the door.
4. Close the door and make sure that it
latches securely.
Partially Install A
Screw In This Hole
4. Insert the new handle into the side open-
ing of the door. Make sure that the handle
seats all the way in the opening, and that
the holes are all aligned properly, then
mount the handle with two screws.
5. Using a small screwdriver, remove the
hole plugs in the door opening of the dryer,
and install them in the former screw holes
in the other side of the dryer. Be careful not
to damage the finish.
REINSTALL THE DOOR
1. If necessary, clean both sides of the door
glass before reassembling it.
2. Place the inner door assembly into the
outer door assembly and align the hinge in
the opening on the side. Fit the inside door
assembly edge completely inside the outer
door assembly.
3. Loosely install the six screws in the door.
Once all of the screws are loosely in-
stalled, and the edges of the door are
properly aligned, tighten the screws se-
curely.