Whirlpool duet GEW9200L Series, Job Aid

Page: 45 / 68

4-13
11. To remove a roller:
a) Pry the sides of the triangular ring out
of the groove in the roller support with
a small screwdriver.
c) Use a 9/16
″
socket or open-end
wrench, and remove the hex nut and
flat washer from the roller support, and
remove the support. NOTE: If you are
replacing the roller support, remove the
other triangular ring from the support.
9/16
″
Nut & Flat Washer
Triangular
Ring
Roller Support
Roller Support
Triangular Ring
b) Slide the roller off the roller support.
NOTE: There are two rollers on the front panel
and two on the rear panel, as shown below.
Front Rollers
Rear Rollers
Rear Panel (inside)
Front Panel (inside)
DRUM INSTALLATION NOTE: Be sure to po-
sition the drum with the clip toward the front
when you reinstall it.
Front
Install Drum
Position Clip
Towards Front