Whirlpool AER5522VAS0, Manual

Page: 37 / 70

28 1-
F5 E1 (Door Latch Switch)
Run Diagnostic Mode and verify •
fault code
While in Diagnostic Mode - Start •
Clean cycle, to verify door does latch.
• Unplug range or disconnect power.
If door did not latch - check for
contunity at CON3-4 to CON3-1
If no contunity - check for 500-3000Ω •
resistance at CON1-4 to CON1-1
If resistance check fails - replace •
Latch motor.
If resistance check is good, check •
door (slot) and latching rod
alignment.
If door alignment is good - •
Replace Door Latch Switch •
LCC Fault Code Procedure (continued)