page 3 – 15
AM-55 / Sep 2015
A M - 5 5 G U I
3. The third method is by direct value entry. By double clicking on the value boxes
underneath each slider, a dialog opens up which allows keyboard entry of the
operating values for each equalizer section. Once the value has been typed into
the entry box, clicking the
OK
button or hitting the keyboard
Enter
key will make
the value active. Note that the direct entry method is controlled by a lookup table
of all possible values. If an entry is made that is not in the lookup table, the closest
lookup table entry will be made active.
Manipulating Equalization Curves via Mouse
Double clicking on the small crosshair at the top (or bottom if it’s below the line)
of the curve turns that section on and off (white arrow)
Clicking on the crosshair and holding the left mouse button down as you drag the
mouse will move the curve to any frequency (left or right move) as well as adjust the
curve’s height above or below the 0dB reference line (up or down move).
Clicking on the small “tent” underneath (see red arrow), and holding the left mouse
button down while sliding the mouse left or right allows changes the bandwidth, or “Q,”
of the equalizer section.
EQ Enable
This is the master Equalizer In/Out button. When the
Enable
box is checked the
equalizer section is “IN”.
