ASSEMBLY STEP 4: SECURING THE GAS LINE
F
HARDWARE
HARDWARE
BAG
1. Using the Zip Tie, secure the Hose to underside of the
Control Panel.
FIGURE 10
2. Tighten the zip tie so that there is no slack remaining.
DO NOT over-tighten the Zip Tie to help prevent the hose
from coming into contact with the hot Burner Chamber.
OVER-TIGHTENING may restrict gas flow and could
damage the gas line.
3. Inspect the installation underneath the Smoker to ensure
that the Hose is not rubbing any portion of the Burner
Chamber.
4. Carefully turn the Smoker upright onto its Legs.
ASSEMBLY STEP 5: DAMPER PLATE INSTALLATION
1. Set one Damper Plate on top of the Cabinet and line it up with the
corresponding “butterfly” holes.
FIGURE 11
2. Insert a Bolt from the top through the center hole.
3. From the bottom side, place a Lock Washer and Nut on the Bolt.
4. Thread the Nut just tight enough to keep the Damper Plate snug, it
should be able to rotate with little resistance.
5. Repeat steps 1-4 on the other 2 sides with the Dampers Plates.
FIGURE 10
ZIP TIE
BURNER
CHAMBER
HVR
HOSE
CONTROL
PANEL
3 NUTS
3 LOCK WASHERS
3 BOLTS
LOCATE THESE PARTS
HARDWARE
TOOLS NEEDED
HARDWARE BAG
3 DAMPER
PLATES
B
PHILLIPS
HEAD
SCREWDRIVER
3/8” WRENCH
CABINET
PANEL
BOLT
DAMPER
FIGURE 11
LOCK WASHER
NUT
“BUTTERFLY”
HOLES IN
CABINET
ENGLISH INSTRUCTIONS
9
