ASSEMBLY STEP 3 CONTROL PANEL / HVR SYSTEM / IGNITOR INSTALLATION
Tools needed:
LOCATE THESE PARTS
TOOLS NEEDED
IGNITOR
KNOB
CONTROL
KNOB
CONTROL
PANEL
ASSEMBLY
1. Leave the Cabinet positioned upside down.
2. Attach the Ignitor Knob and the Control Knob to the Control
Panel Assembly.
FIGURE 5
Make sure the Control Knob
properly seats on the keyed shaft.
FIGURE 6
3.Line up the Control Panel.
FIGURE 7
4.The (Hose/Valve/Regulator) HVR stem must be inserted into
the Venturi.
FIGURE 8
WARNING! Improper installation may
cause a fire outside of the Smoker!
5.When sliding the Control Panel into place, make sure the tabs
capture the front Legs.
FIGURE 9
6.Connect the Ignitor wire to one of the prongs on the Ignitor.
FIGURE 9
7.Insert the 2 remaining Bolts from Hardware Bag A through the
tabs on the Control Panel and thread them into the mounting
holes.
FIGURE 8
8. Firmly tighten all of the Bolts, including the loose Bolts
on the front Legs.
FIGURE 5
FIGURE 7
HVR STEM
inserted into the
VENTURI.
REMAINING
BOLT
FIGURE 8
Be sure the tab fits
around both sides
of the LEG.
IGNITOR WIRE
connects to
the IGNITOR.
FIGURE 9
A
HARDWARE
HARDWARE BAG
NOTE:
Hardware Bag
A includes 12 Bolts.
You will need 2 bolts
for this step. The other
10 bolts were used in
Step 2.
CONTROL
PANEL
ASSEMBLY
IGNITOR
KNOB
CONTROL
KNOB
VENTURI
HOSE
PHILLIPS
HEAD
SCREWDRIVER
TOP
FRONT
FIGURE 6
HVR
ASSEMBLY
2 BOLTS
ENGLISH INSTRUCTIONS
8
