41
I
NSTALLATION
S
ET
-U
P
Figure 103 Installing Burner Cover.
8. Place one of the Permanent Magnets provided on the front edge of the Burner Cover Supports as shown in
Figure 101.
9. Install the Burner Assembly; refer to Step 1 & 2 of
G
LASS
B
URNER
I
NSTALLATION
.
10. Place the Ceramic Burner Front on top of the Burner Cover Supports as shown in Figure 101. This part
should be pulled forward until it contacts the metal brackets in the front.
O
PTIONAL
F
RONT
I
NSTALLATION
:
There are many different styles of optional fronts available for your fireplace. These fireplace fronts hang onto
the front of your fireplace using four (4) hooks, one on each corner (refer to Figure 104). These hooks secure
the front to the fireplace, providing for easy removal for service access to the fireplace and also to position the
front the proper distance away from the glass door and the fireplace facing.
11. The Burner Cover has two (2) slots, one the either
side of the rear flange (refer to Figure 102). These
slots fit over the two (2) studs in the firebox (refer to
Figure 101) to keep it in place.
The arrows in Figure 103 point at the studs that hold
the Burner Cover in position. Place the Burner Cover
over the pins and then once aligned with the holes,
push the Burner Cover back towards the rear of the
firebox. The front of the Burner Cover is held in place
by the permanent magnets installed in step 8.
12. Install the Glass Tray and the Glass to complete the
installation of the Porcelain Panel Kit, refer to Step 3,
4, 5, & 7 of
G
LASS
B
URNER
I
NSTALLATION
.
Figure 104: Optional Front Parts.
Figure 105: Optional Front Being Installed.
Summary of Contents for DV48
Page 52: ...WIRING HARNESS 52 ...
Page 57: ...PARTS DIAGRAM 57 ...
