35
I
NSTALLATION
S
ET
-U
P
Figure 73: Tab on Firebox Grate.
Figure 72: Slot for Firebox Grate.
4. Install the burner accent pieces as shown in
Figure 71. There are a left, a right and a front
ceramic trim. On each side of the burner and
on the inside of each burner side accent pieces
there is a slot, which should be aligned in order
to position the log grate correctly (see Figure
70).
5. The firebox grate has two (2) tabs that run
below the feet of the grate (see Figure 73),
place the grate over the burner top and carefully
inserting the grate tabs into the slots on the
burner (see Figure 72 & 74). Once the grate is
installed correctly, the burner, grate, and side
burner accents will be all locked together.
Figure 74: Firebox Grate in Place.
L
OG
S
ET
I
NSTALLATION
:
IMPORTANT: The paint on the logs may fade for the first 8-10 hours of burn time, but will come back to its
color after the paint has curred. The paint is very delicate and handing them with care is nessesary not to
mark or smuge the paint.
1. Install Right Rear Log. The right side sits on the
grate with the groove on the bottom of the log
fitting onto the top of the grate (see Figure 75).
Insert the log pin into the top of the ember burner (see A in Figure 75). Align the log front edge with the
front section of the grate (see B in Figure 75).
Figure 75: Log 1 in Place.
Figure 76: Log 2 in Place.
Summary of Contents for DV48
Page 52: ...WIRING HARNESS 52 ...
Page 57: ...PARTS DIAGRAM 57 ...
